ZyXEL Communications Prestige 100WH - Manual (Page 61)

Prestige 100WH Internet Access Router
4-1 Chapter 4 Remote Node Configuration
Chapter 4
Remote Node Configuration
A remote node is required for placing calls to a remote gateway. A remote node represents
both a remote gateway and the network behind it, across a WAN connection. Please note that
when you use Menu 4 to configure the Internet access, you are actually configuring one of the
four remote nodes available in your Prestige. Once a remote node is configured properly,
traffic to the remote network will trigger your Prestige to make a call automatically (i.e., Dial
On Demand).
4.1 Remote Node Setup
This section describes the configuration of protocol-independent parameters for the remote
node.
4.1.1 Remote Node Profile
To configure the remote node parameters, follow these steps:
Step 1. From the Main Menu, select menu option [11. Remote Node Setup]
Step 2. When Menu 11 appears, as shown in Figure 4-1, enter the number of the remote
node (1-4) that you wish to configure.
Figure 4-1. Menu 11 - Remote Node Setup
Menu 11. - Remote Node Setup
1. ________
2. ________
3. ________
4. ________
Enter Node # to Edit: