ZyXEL Communications U-336SA - Manual (Page 92)

78 Fax Operation
Command Value Description
+FNS="string" Non-standard byte string parameter.
"string": string of hexadecimal coded
octets.
+FPI="string" Local fax station ID string, for polling Rx.
+FPR=n Serial port rate control parameter:
n=0 Automatic DTE rate detection by the
DCE.
n>0 Serial rate is fixed at the value multiplied
by 2400 bps. For example, when n=8, the
DTE rate is equal to 19200 bps (8x2400).
+FPS=n Page transfer status: refer to the +FPTS
Class 2 command in previous sections for
settings.
+FRQ=pgl,cbl Receiving quality threshold parameters:
pgl=
0-64
(HEX
value) Specify the percentage of good lines (e.g.
with negotiated number of pixels) required
for a page considered acceptable. The
percentage of good lines would be
computed by the equation:
100 x ( - ) /
lc: total line count as reported in the +FPS:
response.
bl: bad line count as reported in the +FPS:
response.
If the resulting value is less than the value
in , the page is unacceptable.
cbl=
0-FF
(HEX
value) Specify the maximum tolerable number of
consecutive bad lines. If this value is
exceeded for a given page, the DCE shall
consider the page unacceptable.
+FSP=n Enable polling command: