ZyXEL Communications U-336SA - Manual (Page 35)

Basic Modem Operation 21
Storing Phone Numbers
The AT command to store a phone number is in the format AT&Zs=n.
The ‘s’ is a number from 0 to 49 that represents the location in memory
that the phone number is to be stored, and the ‘n’ is the phone number
itself.
Example: To store the number ‘1-714-555-1212’ in memory location
‘2’, type:
AT&Z2=17145551212
You can store up to 50 telephone numbers.
Dialing Stored Phone Numbers
The AT command syntax used to dial a stored number is ATDS=n.
The ‘n’ is the memory location of the stored number you want to dial.
ON OTE
: A
S A GENERAL RULE
,
WHEN A LETTER IN AN
AT
COMMAND DEFINITION IS
SHOWN IN ITALIC TYPE
,
THE LETTER IS NOT TO BE ENTERED AS PART OF THE
COMMAND
,
BUT RATHER IS REPRESENTATIVE OF A NUMBER OR STRING
EXPECTED AS INPUT
. F
OR EXAMPLE
: T
HE LETTER ‘S’ IN THE
ATDS=
N
COMMAND IS ACTUALLY TYPED
,
UNLIKE THE ‘ S ’ IN THE
AT&Z
S
=
N COMMAND
WHICH REPRESENTS A NUMBER
.
Saving Settings and User Profiles
There are some cases where you may wish to save the settings you
have made as the default settings that are recalled when your modem is
powered up. The AT&WZ command selects the current settings as the
power-on profile.
There are four profiles that can be changed by the user, and one factory
default profile. The following table lists the syntax for the commands
involved in storing, recalling, and viewing profile settings: