ZyXEL Communications U-336SA - Manual (Page 47)

LCD Panel Operation 33
Equivalent AT Commands:
AT&Z? View all stored phone numbers.
AT&Zn=1234567 Store phone number in memory location n (n=0-
49).
Up to 50 different numbers can be viewed and set. If you want to add a
number to the memory, select an unused memory location and press
ENTER. The blinking cursor will change into an underscore and will
move to the next position on the right side of the colon. SELECT
MEMORY will change to SELECT DIGIT. Press the left and right
arrow keys to scroll through the valid digits and characters for dialing.
Pressing ENTER will confirm the selected digit and cause the cursor to
move to the next position.
Repeat the above procedure to finish entering the number, then press
ENTER again to save the entry in the EEPROM. The stored numbers
will remain in the memory until you revise or delete them. Pressing the
up arrow key in the process will abort and exit the current number entry
and nothing will be changed or saved.
View and Store a Number
If you want to view or store a phone number into the EEPROM in lease
line operation or data state. You can select “PHONE NUMBER”
screen and enter it. The operation is the same as the above.
Dialing a Number
The same procedure as in the STORE NUMBER operation is used
when entering numbers. Once the number entry is completed, press the
ENTER key to dial the number.
_ 1234567_
<< >> SELECT MEMORY << >> SELECT MEMORY