ZyXEL Communications U-336SA - Manual (Page 100)

86 Fax Operation
automatically, handshakes the multi-page procedure with the remote
facsimile and sends the next page.
The following flow control signaling is used while receiving a fax:
•
CTS is not used when receiving fax.
•
RTS is used to inform your modem that the computer cannot accept
data at this moment. The modem will not pass received data to the
DTE if RTS is turned off.
When finished receiving the fax message, your modem will turn off CD
then send a status report result code to the DTE.
Fax Reception from a BBS
The U-336S/SA can automatically detect data and fax calls and allow
BBS software to receive faxes on the same phone line. To allow your
BBS to receive incoming faxes, make the following set-up changes in
your BBS:
1. Add the string #B1+FCLASS=6 to the init string. Be sure the
+FCLASS=6 command is the last command.
2. Change one of the messages in the list to CONNECT FAX.
3. Set the external mail string to ZyXEL and give it an error level.
4. In your BBS batch file, if the error level matches the external mail,
execute
rcvfax 2 /p:comport [/w:workpath]
This setting will enable the BBS to receive a fax and store it
automatically.
The following is a sample setting for the FrontDoor system.