5 resetting the wpa-1000 to its factory defaults, Resetting the wpa-1000 to its factory defaults, Section 5.5 – ZyXEL Communications WPA-1000 User Manual
Page 58
Chapter 5 Troubleshooting
WPA-1000 User’s Guide
58
5.5 Resetting the WPA-1000 to Its Factory Defaults
If you reset the WPA-1000, you lose all of the changes you have made. The WPA-1000 re-
loads its default settings. Default settings include:
• Password of conference control host and administrator: 1234
• SSID: ZyXEL
• Server IP: 192.168.1.10
• WEP: disabled
• Gatekeeper: All Block
• Resolution: 1024 by 768
• Color depth: 32bit
• Refresh rate: 60Hz
"
You will lose all of your changes when you push the RESET button.
To reset the WPA-1000,
1 Make sure the STATUS LED is on and not blinking.
2 Use a pointed device such as a pen to press the RESET button in for 30 seconds. Turn the
device on and off.
3 Release the RESET button when the STATUS LED begins to blink.
4 When the WPA-1000 restarts automatically, wait for the WPA-1000 to finish restarting,
and log in to the web configurator. The default settings have been restored.
If the WPA-1000 does not restart automatically,
di
sconnect and reconnect the WPA-1000’s
power. Then, follow the directions above again.