2 wpa-1000 access and login, Wpa-1000 access and login – ZyXEL Communications WPA-1000 User Manual
Page 54
Chapter 5 Troubleshooting
WPA-1000 User’s Guide
54
V
My WPA-1000 cannot connect to a projector. The standby screen does not
appear.
1 Check the projector is turned on and working properly.
2 Check your gray VGA cable is securely attached to the WPA-1000 and to the projector.
3 Turn the projector off and then on.
5.2 WPA-1000 Access and Login
V
I forgot the IP address for the WPA-1000.
1 The default IP address is 192.168.1.10.
2 If you changed the IP address and have forgotten it, you might get the IP address of the
WPA-1000 by looking up the IP address of the default gateway. To do this in most
Windows computers, click Start > Run, enter cmd, and then enter ipconfig. The IP
address of the Default Gateway might be the IP address of the WPA-1000 (it depends
on the network), so enter this IP address in your Internet browser.
3 If this does not work, you have to reset the device to its factory defaults. See
.
V
I forgot the password.
1 The default password is 1234.
2 If this does not work, you have to reset the device to its factory defaults. See
.
V
I cannot see or access the Login screen in the web configurator.
1 Make sure you are using the correct IP address.
• The default IP address is
192.168.1.10
.
• If you changed the IP address (
), use the new IP address.
• If you changed the IP address and have forgotten it, see the troubleshooting
suggestions for
I forgot the IP address for the WPA-1000.
2 Check the hardware connections, and make sure the LEDs are behaving as expected. See
the Quick Start Guide and
.