3 projection problems, Projection problems – ZyXEL Communications WPA-1000 User Manual
Page 56
Chapter 5 Troubleshooting
WPA-1000 User’s Guide
56
2 There may be too much radio interference (for example microwave or another AP using
the same channel) around your wireless network. Lower the output power of the AP if
your AP has this option.
3 Make sure there are not too many computers connected to the WPA-1000.
V
I cannot log in to the WPA-1000 Administrator screens.
1 Make sure you have entered the password correctly. The default password is 1234.
2 Turn the WPA-1000 off and on.
3 Disconnect and re-connect the power adaptor or cord to the WPA-1000.
4 If this does not work, you have to reset the device to its factory defaults. See section
5.3 Projection Problems
V
I cannot install the projection utility from my web browser.
1 Insert the support CD in the package into your CD-ROM.
2 Click Setup, or you can find the setup.exe file in the directory of your CD-ROM and
then double-click it.
3 The installation wizard appears.
4 After the successful installation and reboot of your computer, double click the WPA-
1000 shortcut (
) on your desktop.
V
The projection is unclear.
1 Click Refresh in the projection utility.
2 Check the resolution settings and refresh rate for your projector. Make sure the WPA-
1000 has the same settings - see
V
I cannot use the WPA-1000 utility to project my presentation.
1 Uninstall the WPA-1000 utility and reinstall it.
2 Check you have permission to join the network. For example, check you are not kicked
out. See
for more information.