ZyXEL Communications WPA-1000 - Manual (Page 27)

Chapter 2 WPA-1000 Hardware
WPA-1000 User’s Guide
27
2.3 Standby Screen
Connect the WPA-1000 to the projector (see the Quick Start Guide for instructions). The next
screen appears on your projector screen when your WPA-1000 is successfully connected to the
projector. It contains important information that you should write down. You will need this
information later.
Figure 6 Standby Screen
The table below describes the labels on the screen.
LAN Green On The device has a successful LAN connection.
Blinking The WPA-1000 is sending/receiving data.
Off The LAN is not connected.
WLAN Green On The device has a successful wireless
connection.
Blinking The device is sending/receiving data through the
wireless LAN.
Off The device has no wireless connection.
Table 2 Front Panel LEDs (continued)
LED COLOR STATUS DESCRIPTION
Table 3 Standby Screen
LABEL DESCRIPTION
LOGIN CODE You need to enter this number after you install the projection sharing utility in order
to log into it.
SSID This is the name that identifies the WPA-1000 wireless network. Computers must
use the same SSID, channel and WEP as the WPA-1000 in order to connect
wirelessly to it.