ZyXEL Communications WPA-1000 - Manual (Page 45)

Chapter 4 The Web Configurator Screens
WPA-1000 User’s Guide
45
Figure 26 Network
The following table describes the labels in the Network screen.
Table 12 Network > Network
LABEL DESCRIPTION
IP Setup
Obtain an IP
address
automatically
Select this option if a DHCP server either in your network or at your ISP will
assign an IP address to the WPA-1000. The WPA-1000 utility can find WPA-
1000s in your network and also display their IP addresses.
IP Address Select Use the following IP address if you want to assign a static IP address to
the WPA-1000. Type the IP address in the IP address field. The default IP
address is 192.168.1.10.
Subnet Mask Type a subnet mask for the WPA-1000 here. The default subnet mask is
255.255.255.0. For more information on IP addresses and subnet masks, see
Appendix D on page 83 .
Default Gateway The default gateway is the immediate neighbor of your WPA-1000 that will
forward traffic to the destination. Type the IP address of the gateway.
DHCP Server
Setup
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows
computers to obtain TCP/IP configuration at startup from a server.
Auto Select Auto to enable DHCP server so the WPA-1000 can assign TCP/IP
information (IP addresses and subnet masks) to network devices in your
network.
Start IP Type the first IP address in the range of contiguous addresses that the WPA-
1000 will assign to network devices in your network. To avoid an IP address
conflict, the IP address range should not include your WPA-1000’s IP address
but it should be in the same subnet.
End IP Type the last IP address in the range of contiguous addresses that the WPA-
1000 will assign to network devices in your network. To avoid an IP address
conflict, the IP address range should not include your WPA-1000’s IP address
but it should be in the same subnet.