ZyXEL Communications WPA-1000 - Manual (Page 53)

WPA-1000 User’s Guide
53
C
H A P T E R
5
Troubleshooting
This chapter offers some suggestions to solve problems you might encounter. The potential
problems are divided into the following categories.
• Power, Hardware Connections, and LEDs
• WPA-1000 Access and Login
• Projection Problems
• Internet Access Via the WPA-1000
• Resetting the WPA-1000 to Its Factory Defaults
5.1 Power, Hardware Connections, and LEDs
V
The WPA-1000 does not turn on. None of the LEDs turn on.
1 Make sure the WPA-1000 is turned on.
2 Make sure you are using the power cord included with the WPA-1000.
3 Make sure the power cord is connected to the WPA-1000 and plugged in to an
appropriate power source. Make sure the power source is turned on.
4 Turn the WPA-1000 off and on.
5 If the problem continues, contact the vendor.
V
One of the LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the LED. See Section 2.2 on page 26 .
2 Check the hardware connections. See the Quick Start Guide and Section 2.1 on page 25 .
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Turn the WPA-1000 off and on.
5 If the problem continues, contact the vendor.