Western Telematic AFS-16-1 - Manual (Page 75)

7-8
Alarm Configuration
• Email Message: Enables/Disables email notification for this alarm. (Default = On.)
Note: If either of the "Copy to All Triggers" options is selected, then email
notification for other alarms will be switched On or Off as indicated by this
parameter.

Address 1, 2, and 3: These parameters are used to determine which of
the three email addresses defined via the "Email Messages" menu (see
Section 5.9.11) will receive the email alarm notification messages generated
by this alarm. The Address parameters can be used to select one, or any
combination of the addresses defined via the Email Messages menu.
(Default = All On.)
Note: If Email addresses have been previously specified, then the text under
the parameters will list the current, user defined email addresses.
• Subject: This parameter is used to define the text that will appear in the "Subject"
field for all email notification messages generated by this alarm. (Default = "Alarm:
Invalid Access Lockout.")
• Contact Output Enable: Activates/deactivates the output contacts on the Control
Module AUX Connector. When the Contact Output Enable parameter is set to "On",
the Common line will be switched from the Normally Closed contact to the Normally
Open contact when an Invalid Access Lockout Alarm is generated. For more
information on the Output Contacts, please refer to Section 7.1. (Default = On.)
Note: If either of the "Copy to All Triggers" options is selected, then the Contact
Output Enable parameter for other alarms will also be enabled or disabled as
specified by this parameter.