Western Telematic AFS-16-1 - Manual (Page 60)

5-39
Basic Configuration

Circuit Access: Selects the default Circuit Access setting for new TACACS
users. The Circuit Access setting determines which Circuit Module(s) each
account will be allowed to control. (Defaults; Administrator and SuperUser =
All Circuits On, User = All Circuits Off, ViewOnly = All Circuits Off.)
Notes:
• Administrator and SuperUser level accounts always have access to all
circuits.
• User level accounts will only have access to the circuits that are defined via
the "Circuit Access" parameter.
• ViewOnly accounts are not allowed to invoke switching commands.

Circuit Group Access: Selects the default Circuit Group Access setting for
new TACACS users. For more information on Circuit Groups, please refer to
Section 5.6. (Defaults; Administrator and SuperUser = All Circuit Groups On,
User = All Circuit Groups Off, ViewOnly = All Circuit Groups Off.)
Notes:
• In order to use this feature, Circuit Groups must first be defined as described
in Section 5.6.
• Administrator and SuperUser level accounts will always have access to all
Circuit Groups.
• User Level accounts will only have access to the Circuit groups that are
defined via the Circuit Group Access parameter.
• ViewOnly accounts are not allowed to invoke switching commands.

Service Access: Selects the default Service Access setting for new TACACS
users. The Service Access setting determines whether each account will be
able to access command mode via Serial Port, Telnet/SSH or Web. In addition,
the Service Access setting also determines whether each account will be able
to employ the Outbound Access function. For example, if Telnet/SSH Access is
disabled, then the default setting for new TACACS accounts will not allow access
to command mode via Telnet or SSH. (Default = Serial Port = On, Telnet/SSH =
On, Web = On.)
Note: If Outbound Access has been disabled via the Network Parameters
menu, then the Service Access parameter will not be allowed to grant Outbound
Access to new TACACS users.