Western Telematic AFS-16-1 User Manual
Page 73

7-6
Alarm Configuration
• Email Message: Enables/Disables email notification for this alarm. (Default = On.)
Note: If either of the "Copy to All Triggers" options is selected, then email
notification for other alarms will be switched On or Off as indicated by this
parameter.
Address 1, 2, and 3: These parameters are used to determine which of the
three email addresses defined via the "Email Messages" menu will receive
the email alarm notification messages generated by this alarm. The Address
parameters can be used to select one, or any combination of the addresses
defined via the Email Messages menu. (Default = All On.)
Note: If Email addresses have been previously specified, then the text under
the parameters will list the current, user defined email addresses.
• Subject: This parameter is used to define the text that will appear in the "Subject"
field for all email notification messages that are generated by this alarm.
(Default = "Alarm: Ping-No-Answer")
• Contact Output Enable: Activates/deactivates the Output Contacts on the
AFS-16 Control Module AUX Connector. When the Contact Output Enable
parameter is set to "On", the Common line will be switched from the Normally
Closed contact to the Normally Open contact when a Ping-No-Answer Alarm
is generated. For more information on the Output Contacts, please refer to
Section 7.1. (Default = On.)
Note: If either of the "Copy to All Triggers" options is selected, then the Contact
Output Enable parameter for other alarms will also be enabled or disabled as
specified by this parameter.