Western Telematic AFS-16-1 - Manual (Page 117)

17-4
Command Reference Guide
/L Log Functions
Provides access to a menu which allows you to display the Audit Log, Alarm Log and
Temperature Log. For more information on Log Functions, please refer to Section 5.3.4.
Availability: Administrator, SuperUser
Format:
/L [Enter]
/J Display Site ID / Unit Information
Displays the user-defined Site I.D. message. If the optional asterisk (*) argument is
included in the command line, the command will also show the model number and
software version for the AFS-16 unit.
Availability: Administrator, SuperUser, User, ViewOnly
Format:
/J [*] [Enter]
Where * is an optional argument, which can be included in the command line to
display the exact model number and software version of the AFS-16 unit.
17.3.2. Control Commands
/X Exit Command Mode
Exits command mode. When issued at the Network Port, also ends the Telnet session.
Note: If the /X command is invoked from within a configuration menu, recently
defined parameters may not be saved. In order to make certain that parameters
are saved, always press the
[Esc] key to exit from all configuration menus and
then wait until "Saving Configuration" message has been displayed and the
cursor has returned to the command prompt before issuing the /X command.
Availability: Administrator, SuperUser, User, ViewOnly
Format:
/X [Enter]
/C Connect
This command can be used to establish a bidirectional connection between the Serial
Port and the Network Port.
Note: User level accounts can only connect to the Serial Port or Network port
if access to the port has been specifically enabled for the account.
Availability: Administrator, SuperUser, User
Format:
/C [Enter]
Where x indicates the port that you wish to connect to. To connect to the Network
Port from the Serial port, enter an N; to connect to the Serial Port from the Network
Port, enter a 1.