Western Telematic AFS-16-1 - Manual (Page 55)

5-34
Basic Configuration
• Authentication Protocol: Determines which authentication protocol will be used.
The AFS-16 supports both MD5 and SHA1 authentication. (Default = MD5.)
Notes:
• The Authentication Protocol that is selected for the AFS-16 must match the
protocol that your SNMP client will use when querying the AFS-16 unit.
• The Authentication Protocol option is not available when the Version
parameter is set to V1/V2
• SNMP Contact: (Default = undefined.)
• SNMP Location: (Default = undefined.)
• Read Only Community: Note that this parameter is not available when the SNMP
Version is set to V3. (Default = Public.)
• Read/Write Community: Note that this parameter is not available when the SNMP
Version is set to V3. (Default = Public.)
Note: If identical names are defined for the Read Only Community and
Read/Write Community, then the unit will give priority to the Read/Write
Community option.
5.9.7. SNMP Trap Parameters
These menus are used to select parameters that will be used when SNMP traps are
sent. For more information on SNMP Traps, please refer to Section 12. Text Interface
and Web Browser Interface allow the following parameters to be defined:
• SNMP Manager 1: The IP Address for the first SNMP Manager. For more
information, please refer to Section 12. (Default = Undefined.)
Note: In order to enable the SNMP Trap feature, you must define at least one
SNMP Manager.
• SNMP Manager 2: (Default = Undefined.)
• Trap Community: (Default = Public.)