Western Telematic AFS-16-1 - Manual (Page 12)

2-2
Unit Description
2.2. The Control Module
The Control Module, shown in Figure 2.2, coordinates switching of the individual Circuit
Modules. The Control Module includes a Master A/B Gang Switch, status LEDs, a
10/100Base-T Ethernet connector and an RJ-45 RS232 Serial Port for connection to your
PC, control device or external modem. An AUX jack is provided to allow connection to
a monitored line and optional external alarm. The AFS-16 always includes one Control
Module.
AC
LK
ETHERNET
10/100
A
ALARM
RST
B
CONTROL
RS232
1
2
3
4
5
6
7
Figure 2.2: The Control Module
The AFS-16 Control Module includes the following components:
 Ethernet Port: An RJ45 Ethernet port for connection to your 10Base-T or
100Base-T, TCP/IP network. Note that the AFS-16 features a default IP address
(192.168.168.168). This allows you to establish an SSH connection with the unit
without first assigning an IP address. Note that the Network Port also includes two,
small LED indicators for Link and Data Activity. For more information on Network
Port configuration, please refer to Section 5.9.
 Master A/B Gang Switch: Allows manual control of A/B switching at up to sixteen
Circuit Modules. Note that the Master A/B Gang Switch can be disabled as
described in Section 5.3.
 ALM Indicator: The ALM Indicator will light when Monitor Input Alarm is triggered.
For more information on the Monitor Input Alarm, please refer to Section 7.6.