2 automatic diagnostic printing - 6 – Toshiba B-570 SERIES User Manual
Page 96

6-6
EM18-33010A
6. DIAG. TEST OPERATION
NOTES: 1. If the automatic diagnosis printing results in an error, the printer will display the error
message and stop printing. The error status can be cleared by the [PAUSE] key,
however, the display will return to the initial display “<1> DIAGNOSTIC V1.0A”.
Printing is not automatically resumed.
2. Both label and tag paper can be used for printing.
(Revision Date Jan. 13, ’95)
6.2 SLEF TEST MODE
The data from
1
to
9
on a sample print is printed.
< 1
D I A G N O S T I C
V 1 . 0 A
>
Power off
C H
C K I N G
&
P R I N T I N G
E
A U
O M A T I C
D I A G N O S T I C
T
R I
B O N
T R A N S M I S S I V E
B
Select the ribbon type from those
at the right by pressing the
[FEED] key or [RESTART] key.
Press the [PAUSE] key.
Press the [FEED] key.
Press the [PAUSE] key.
The printer is checking or printing
the status
The result of the self test
is printed. After printing,
the initial display will be
shown.
NO RIBBON (No ribbon : Thermal direct)
TRANSMISSIVE
(Transmissive ribbon : Thermal transfer)
NO TRANS.
(Non-transmissive ribbon : Thermal transfer)
Press the [PAUSE] key.
Continued on Section 6.2.3
Head Broken Element Check.
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [PAUSE] key.