Toshiba B-570 SERIES - Manual (Page 141)

6-51
EM18-33010A 6. DIAG. TEST OPERATION
NOTE: Pressing the [PAUSE] key validates the sensor setting. The value of the sensor is
displayed up to 5.0 V.
6.5.4 Paper End Setting for Black Mark Sensor
Paper end setting should be performed after replacing the CPU PC board or changing the tag paper
to other maker’s one, or when a paper feed error occurs.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key three times.
Remove any paper
from the sensor detecting
area.
Holding the [FEED] key or
[RESTART] key down until
an asterisk ( * ) is displayed.
(More than 3 seconds.)
Ex)
The former value is displayed.
Indicates setting complete.
Press the [PAUSE] key four times.
< 1 D I A G N O S T I C V 1 . O A >
< 4 S E N S O R A D J U S T M E N >
[ P L E V E L . R ] 4 . 3 V
T
E
[ P L E V E L . R ] 4 . 3 V * E (See NOTE.)
Press the [PAUSE] key for
Paper End Setting for
Feed Gap Sensor.
Press the [FEED] key
and [RESTART] key
at the same time.
(Revision Date: Jan. 14 ’99)
6.5 SENSOR SETTING MODE