2 process test print -46 – Toshiba B-570 SERIES User Manual
Page 136

6-46
EM18-33010A
6. DIAG. TEST OPERATION
In the process test print, the test print is automatically performed on the following conditions.
Parameter setting and print tone fine adjustment value is ignored.
•
OPERATION
: One label feed, 3-dot slant line print, bar code print, character print
•
ISSUE COUNT : 5 labels each
•
PRINT SPEED : 8 inches/sec.
•
SENSOR
: Transmissive sensor (feed gap sensor) or reflective sensor (black mark
sensor)
•
RIBBON
: Transmissive ribbon
•
TYPE
: Batch (without cut)
•
LABEL LENGTH: 76 mm
•
PRINT TONE FINE ADJUSTMENT VALUE : + 0
Operating procedure for the test mode is provided below.
(Revision Date Jan. 13, ’95)
6.4 TEST PRINT MODE
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key twice.
Press the [PAUSE] key.
Press the [RESTART] key.
Press the [PAUSE] key.
[Bar codes are printed on 5 labels.]
After feeding one label, slant
lines (3 dots) are printed on 5
labels.
Press the [RESTSRT]
key.
Press the [FEED] key
and [RESTART] key
at the same time.
< 1
D I A G N O S T I C
V 1 . O A
>
< 3
T E S T
P R I N T
>
P R
N T
C O N D I T I O N
I
A U
O
P R I N T ( R E F L E C T . )
T
From C on
the next page.
To A of the
preceding page.
To C of the
preceding page.
To be continued on
B of the next page.