Toshiba B-570 SERIES - Manual (Page 149)

7-3
EM18-33010A 7. PROGRAM DOWN LOAD
(Revision Date: Feb. 10, 2000)
7.1 DOS VERSION
B
Error
code
Check the following when an error occurs:
•
The printer power is turned on.
•
The RS-232C cable or high speed PC interface cable is connected properly.
•
The DIP SW on the CPU PC board or BPC PC board is set correctly.
•
With the high speed PC interface, that the BPC/BPE PC boards are installed in the PC/printer
properly. That the BPC driver is installed in the PC (hard disk drive) properly.
(11) When an error occurs, the following message is displayed together with the error code in
line .
The following error occurred during transmission. (ERROR=##)
Press any key to retry.
Doing so will revert to the displayed described in step (6). Refer to the error code to find the
cause of the error. then retry the down load.
(12) After terminating the down load, refer to the Maintenance Manual Section 6.2 SELF TEST
MODE and perform diagnostic printing. Check that the printer operates properly and the main
program version and checksum is printed on the label.
7.1.4 ERROR CODE
Error Code
(#)
06
07
50
51
57
81
82
88
89
90
92
93
94
95
97
98
99
Error
Communication error
(Error is detected during command analysis.)
Communication error
(Parity error, overrun error or framing error occurred during
communication with RS-232C.)
Write error occurred during formatting of the flash ROM.
Delete error occurred while data was being written onto the flash
ROM.
Chacksum error occurred in the transmission program data.
Image data transmission request signal is not converted to “L”
Data FIFO of the high speed PC interface is not empty.
Underfined status is received when a wating data in RS-232C.
An IOCTL carry is detected in the high speed PC interface.
A parameter error occurred.
An overrun occurred in RS-232C.
A parity error occurred in RS-232C.
A framing error occrred in RS-232C.
A break is detected in RS-232C.
COM1 open error occurred in RS-232C.
Undefined status is received against the loading setup command.
Underfined status is received when the loading operation is
terminated.
Remarks
Status from the
printer
Error detected
in PC