beautypg.com

Toshiba B-570 SERIES User Manual

Page 110

background image

6-20

EM18-33010A

6. DIAG. TEST OPERATION

NOTE: The print stop position when printing the label in strip mode varies according to label length

as the strip mode printing stops so that the edge of the strip shaft is 4 mm from the middle
of the gap. This is because the gap length is programmed as 2mm. When the gap length
is 5 mm or more, the effective print length should be set to the value obtained by
subtracting 2 mm from the label pitch, that is, set the gap length to 2 mm. If the print format
hangs over the gap as a result, correct the print start position. If the print stop position is
improper, refer to Section 6.3.2 and make a fine adjustment.

Fig. 6-14

(Revision Date Jul. 28, ’94)

6.3 PARAMETER SETTING MODE

Strip Position Fine Adjustment Example

- 3.0 mm

+ 3.0 mm

- 3.0 mm

+ 3.0 mm

+ 0.0 mm

Label

Backing Paper

Strip Shaft

Platen

Print Head

Print Head

Platen

Strip Shaft

Backing Paper

Print Head

Platen

Strip Shaft

Backing Paper

Fig. 6-11

Fig. 6-12

Fig. 6-13

4 mm

3 mm

2 mm

Label

Strip Shaft

Backing Paper

Platen