Texas Instruments TMS370 - Manual (Page 75)

Verifying the Contents of a Device
3-25
Once the actual verification begins, it proceeds packet by packet (180-byte
segments). Before a packet is read, the programmer verifies that the source
device address is inside the valid address ranges defined for the current de-
vice type. If the address is not inside the range, the following error message
is displayed.
Address out of range, (press any key)
Press any key to erase the error message and return to the display command
menu.
When verifying against PC memory, the programmer displays a status mes-
sage on the bottom line of the screen to indicate the address currently being
read.
Reading at address 7000 (hit ESC key to abort)
This message is updated when the programmer starts to upload the next pack-
et.
If you want to terminate the uploading process before it has completed, press
to abort the process and return to the display command menu.
When you verify a single device against PC memory and the process is com-
pleted, a message informs you whether or not the verification was successful.
The message for successful verification is:
Verification Complete, verify another device?(y/n)
If you want to verify more devices, in the same or different sockets, using the
same parameter values, press
.