Tascam DP-008 - Manual (Page 81)

TASCAM DP-008
81
Audio input/output ratings
INPUT A jack
• XLR type (Balanced)
Connector: XLR-3-31
(1: GND, 2: HOT, 3: COLD)
Input impedance: 2.4 kΩ
Standard input level: –8 dBu
Maximum input level: +8 dBu
•
1/4” phone jack type (Unbalanced)
Connector: 6.3 mm (1/4”) phone jack
Input impedance:
10 kΩ (when INPUT A selector switch is set
to MIC/LINE )
1 MΩ (when INPUT A selector switch is set
to GUITAR )
Standard input level: –10 dBV
Maximum input level: +6 dBV
Headroom: 16 dB
INPUT B jack
• XLR type (Balanced)
Connector: XLR-3-31
(1: GND, 2: HOT, 3: COLD)
Input impedance: 2.4 kΩ
Standard input level: –8 dBu
Maximum input level: +8 dBu
•
1/4” phone jack type (Unbalanced)
Connector: 6.3 mm (1/4”) phone jack
Input impedance: 10 kΩ or more
Standard input level: –10 dBV
Maximum input level: +6 dBV
Headroom: 16 dB
LINE OUT jack
Connector: RCA pin jack
Standard output level: –10 dBV
Maximum output level: +6 dBV
PHONES jack
Connector: 3.5 mm stereo mini jack
Maximum output level: 20 mW + 20 mW or
more (THD + N 1 % or less, 32Ω load)
Audio performance
Frequency response
INPUT (MIC/LINE) → LINE OUT: 20 Hz to
20 kHz
Distortion
INPUT (MIC/LINE) → LINE OUT: 0.05%
or less
S/N ratio
INPUT (MIC/LINE) → LINE OUT: 81 dB or
more
General
Recording media
SD card (512 MB - 2 GB) or SDHC card (4
GB - 32 GB)
File system
MTR partition: TASCAM original
FAT partition: FAT32
Built-in mic
Omni directional, Stereo
Power supply
Four AA batteries or Optional AC adaptor
(PS-P520)
Battery life
About 5.5 hours (recording, phantom power
off)
About 6 hours (playback)
(When measured with alkaline batteries.
Battery life may vary depending on the
operating conditions)
Operating temperature range
5 - 35°C/41 - 95°F
Power consumption
2.4 W
14 – Specifications and Block Diagram