Tascam DP-008 - Manual (Page 65)

TASCAM DP-008
65
To use the built-in mic, set the
INPUT
SETTING
to
Internal MIC
.
3 When the recorder is stopped, press
TUNER to open the
TUNER
screen.
The value of the
CALIB
item (standard
frequency) is selected.
4 Turn the DATA wheel to set the standard
frequency of the A note between 435 and
445 Hz. The default setting is 440 Hz.
5 Play the instrument and begin tuning.
The pitch name closest to the string
appears above the meters. Tune the
string roughly until the sound name that
you want appears. Then, fine tune the
string until the rectangle at the middle
of the meter darkens, showing that the
string is in tune. If the pitch is too low, a
bar extends to the left of the middle and
if it is too high it extends to the right.
The more out of tune, the longer the bar
appears.
When the pitch played matches the note
shown, the note name appears between the
¥˙
icons.
6 When finished tuning, press the HOME
key to return to the Home Screen.
NOTE
If you want to monitor the input sound,
press the REC key of a track that has INPUT
A assigned to it.
Oscillator mode
1 When the recorder is stopped, press the
TUNER key to open the
TUNER
screen.
2 Press the F4 (
OSC.
) key to display the
oscillator screen.
The following settings can be made on
this screen.
CALIB
Use this to adjust the standard frequency
of A4. The setting range is
435Hz
–
445Hz
.
The default setting is
440Hz
.
NOTE
Use this to set the note output. The
setting range is
C3
–
B5
.
The default setting is
A4
.
LEVEL
Use this to set the output level. The
setting range is
10
(minimum) –
100
(maximum).
9 – Miscellaneous Functions