TANDBERG CONTENT SERVER D13898.04 - Manual (Page 73)

TANDBERG CONTENT SERVER
USER GUIDE
Table of
Contents
What’s New in
this Version?
Trademark/
Licenses
Safety/
Environmental
Introduction Installation Quick Setup Operation
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
D 13898.04
DECEMBER 2006
NAS Configuration

Make sure that your Content Server is on the same as the NAS
Remote desktop into your NAS
Set up a share with a folder inside it
.
•
•
•

Set Permissions and Security settings
on the share to allow the Content Server
Full Control over the share:
Click on Properties > Permissions
Click Add
Click Object Types .
•
•
•

Select the Checkbox for Type – Computers .
Enter (as registered in the domain). If you have not set a new server name through
the Windows Administration site, the default Content Server name is TANDBERG-CS.

Click on Check Names and click OK .
Give User Full Control over the share .

Click on Properties > Security .
Repeat the steps above to give the Content Server full control of the folder
in the Security Settings tab.
Set permissions and security settings on the share to allow the domain
account performing the move full control over the share. Repeat steps as
above, but without checking Computers as the Object Type.
Administrator Settings > Alternate Storage
NAS Configuration