Transition Networks SISGM1040-162D - Manual (Page 15)

Transition Networks SISGM1040-162D-LR
Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
8
Wiring the Fault Alarm Contact
The fault alarm contacts are in the middle of the terminal block connector as the picture
shows below. The switch will provide local indication of a power or port failure, if
configured, by opening the relay contacts. The following illustration shows an
application example for wiring the fault alarm contacts.
Note The wire gauge for the terminal block should be in the range between 12~ 24
AWG.
Insert the wires into the fault alarm contacts (No. 3 & 4)