Olympus C-211 - Manual (Page 56)

56
A coiled covering is installed in the print outlet to
block entry of light. The covering unwinds as the
print begins to emerge from the camera, then
winds back into place before the print is fully
ejected. Please avoid handling this material—it
should never be pulled on, bent, or torn.
To ensure uniform printing, avoid touching the
film’s image area until the image has had time to
stabilize (about 5 to 10 minutes). You can safely
hold the film along the edges or on the white
border.
Waving or bending the film before the image has
stabilized may cause streaks or blotches in the
finished print.
The illustrations below show how the camera prints the image displayed on the monitor.
Note that the print shows slightly less area than the image on the monitor.
Monitor
Print
Light-tight covering
Print
Monitor