Ricoh AP3800C - Manual (Page 92)

Troubleshooting
82
4
Possible Cause Solutions
Is the Data In indicator
blinking or lit after starting
the print job? If not blinking or lit, the data is not being sent to the printer.
❖ ❖ ❖ ❖ If the printer is connected to the computer using the in-
terface cable
Make sure the following printer port settings are correct:
• For a parallel port connection, port LPT1 or LPT2 should be
set.
• For a IEEE 1394 (SCSI print) port connection, port
1394_00(n) *1 should be set.
*1 (n) is the number of printers connected.
• Windows 95/98/Me
A Click [Start], point to [Settings] and then click [Printers].
B Click to select the icon of the printer. Next, on the [File]
menu, click [Properties].
C Click the [Details] tab.
D Check the [Print to the following port] box to confirm that
the correct port is selected.
• Windows 2000
A Click [Start], point to [Settings] and then click [Printers].
B Click to select the icon of the printer. Next, on the [File]
menu, click [Properties].
C Click the [Port] tab.
D Check the [Print to the following port] box to confirm that
the correct port is selected.
• Windows XP
A Access the [Printers and Faxes] window from [Start] on
the taskbar.
B Click to select the icon of the printer. Next, on the [File]
menu, click [Properties].
C Click the [Port] tab.
D Check the [Print to the following port(s).] box to confirm
that the correct port is selected.
• Windows NT 4.0
A Click [Start], point to [Settings] and then click [Printers].
B Click to select the icon of the printer. Next, on the [File]
menu, click [Properties].
C Click the [Port] tab.
D Check the [Print to the following port] box to confirm that
the correct port is selected.
JupP1k_GB_Mainte_F_FM.book Page 82 Thursday, August 22, 2002 4:23 PM