Ricoh AP3800C - Manual (Page 18)

Replacing Consumables and Maintenance Kit
8
1
KKKK
Match (
U U U U) on the front of the Fus-
er Oil Unit and the arrow on the
Fusing Unit as shown in the illus-
tration.
Important
❒ Be careful not to get oil on the
metal point of the left side of the
Fuser Oil Unit.
LLLL
Insert the left and right protru-
sions of the Fuser Oil Unit into
the white holders of the Fusing
Unit (
A A A A), and then move the Fus-
er Oil Unit in the direction shown
by the arrow (
B B B B) to attach the Fus-
er Oil Unit to the Fusing Unit.
MMMM
Holding the green handle with
one hand, use your other hand to
push the front area of the handle
to create a slight slant, and push
the Fusing Unit slowly to the
back.
Note
❒ Confirm that the Fuser Oil Unit
is facing the inside of the print-
er.
At this point, make sure the Fusing
Unit is on the stand properly.
NNNN
Close the upper left cover ( A A A A) and
push the handle slowly (
B B B B) to the
back until it clicks into place.
OOOO
Place the old Fuser Oil Unit into
the bag which contained the new
Fuser Oil Unit, and seal the bag.
ZDJH055J
ZDJH054J
ZDJH050E
ZDJH051J
JupP1k_GB_Mainte_F_FM.book Page 8 Thursday, August 22, 2002 4:23 PM