Ricoh AP3800C - Manual (Page 33)

Replacing the Fusing Unit
23
1
UUUU
Confirm that the A3 paper which
comes with the Fusing Unit is in
the Bypass Tray, and then press
{{{{Enter}}}}.
The printer prints 8 Test Sheet (A -
H). For details about Test Sheet,
see p.41 “Test Sheet Samples”.
Note
❒ It takes about a minute to start
printing.
VVVV
Check the test sheets and select
the correction value for A through
H.
• Select "1", if black and magenta
square overlap sharply and
you can see white slits as the
sample.
• Select "0", if black and magenta
square do not overlap sharply
and you can not see white slits
clearly.
Press
{{{{U U U U}}}} or {{{{T T T T}}}} to select "0" or "1"
as the values for A - H. Press
{{{{En-
ter
}}}} to move to the next letter. After
setting the value for "H", press {{{{En-
ter
}}}}, and the printer returns to the
ready condition.
Important
❒ If you select "0" for each alpha-
bets or an invalid value is select-
e d , a n e r r o r m e s s a g e i s
displayed. In this case, press
{{{{Enter}}}} to return to the ready
condition, and perform the
"Fuser Adjust" manually. See
p.35 “When replacing the fusing
unit”.
❒ When "Toner is Almost Empty"
appears on the panel display,
replace the toner cartridge and
perform the "Auto Adjust", and
then perform "Fuser Adjust"
manually.
Reference
⇒ p.3 “Replacing the Toner
Cartridge”
⇒ p.34 “Auto Adjust”
⇒ p.35 “When replacing the
fusing unit”for "Fuser Adjust"
A B C D E F G H
0 0 0 0 0 0 0 0
Ready
Invalid Value
Press #
JupP1k_GB_Mainte_F_FM.book Page 23 Thursday, August 22, 2002 4:23 PM