Ricoh AP3800C - Manual (Page 75)

Loading Paper
65
3
BBBB
Slide the side guides outward
(
A A A A), and then load paper until it
stops with the print side up (
B B B B).
CCCC
Adjust the side guides to the pa-
per width.
Important
❒ Confirm that the top of the stack
is not higher than the limit mark
inside the tray.
❒ Shuffle the paper before loading
the stack onto the tray so multi-
ple sheets are not fed in at one
time.
DDDD
Set the paper size using the con-
trol panel as follows:
A Press {{{{Menu}}}}.
"Menu" appears on the panel
display
B Press {{{{U U U U}}}} or {{{{T T T T}}}} to "Paper In-
put" menu, and then press
{{{{En-
ter
}}}}.
The following message appears
on the panel display.
C Confirm that "Bypass Size" is
displayed, and then press
{{{{En-
ter
}}}}.
The following message appears
on the panel display.
D Press {{{{U U U U}}}} or {{{{T T T T}}}} to display the
size and direction of the paper
in the bypass tray.
After about two seconds, the
display is returned to the menu.
ZDJH204J
ZDJH205J
Menu:
Paper Input
Paper Input:
Bypass Size
Bypass Size
*11 x 17
ZDJS001J
JupP1k_GB_Mainte_F_FM.book Page 65 Thursday, August 22, 2002 4:23 PM