beautypg.com

Ricoh AP3800C User Manual

Page 81

background image

Error & Status Messages on the Control Panel

71

4

Close Right Cover

The right cover is open.

Close the right cover.

Close Upper Left Cover

The upper left cover (the cov-
er for the fusing unit) is open.

Close the upper left cover.

Driver Setting Error (Memo-
ry)

The printer identified a down-
load error. This error may oc-
cur when the installed
memory amount is less than
the driver setting.

Verify that the paper memory
size is specified with the driv-
er setting.

Duplex Cancelled

The setting of Duplex Print
has been cancelled.

(a) To print the image correct-
ly, add memory to the printer.
(b) Be sure to use the correct
paper.

Error:Tray 1 Reset The Job

/Then Power OffOn

There is a problem with the
current specified tray. The job
can not be processed.

Reset the job then turn the
printer Off, and then back On.

Error:Tray 1 Form Feed

/Or Job Reset Then Power Of-
fOn

The printer identified the fail-
ure of the indicated paper
tray. The job is not printed.

Apply Form Feed from other
tray or cancel the job, and then
switch your printer Off then
back On. If the error contin-
ues, contact your sales or serv-
ice representative.

Exceeded Max. Pages (Col-
late)

The printer identified a colla-
tion page overflow error.

Increase the RAM capacity.

Install the optional hard disk
drive.

Exceeded Max. Stored Files

The maximum number of
stored files has been exceeded
during Sample Print of
Lacked Print.

Delete the stored files.

Exceeded Max. Stored Pages

The maximum number of
pages has been exceeded dur-
ing Sample Print of Lacked
Print

Reduce the number of pages
to print.

Hardware Problem DIMM

The printer identified a DIMM
sum value error.

Remove and re-install the
DIMM correctly.

Remove any dust under the
DIMM.

If the message appears again,
contact your sales or service
representative.

See "Setting Up" in the Setup
Guide.

Hardware Problem Ethernet

The printer identified an Eth-
ernet error.

Turn the power switch off and
then on. If the message ap-
pears again, contact your sales
or service representative.

Messages/Second messages

Description

Solution

JupP1k_GB_Mainte_F_FM.book Page 71 Thursday, August 22, 2002 4:23 PM