Ricoh AP3800C - Manual (Page 26)

Replacing Consumables and Maintenance Kit
16
1
FFFF
Lift the inner cover until it clicks
into place and holds.
The Development Unit is installed
shown in the illustration. Starting
from the upper left, the units are
attached in the order of black (K),
yellow (Y), cyan (C), and magenta
(M).
GGGG
Remove the Development Unit.
The procedure for removing the
unit is the same for all four colors.
A Hook your finger on the green
tab in front of the Develop-
ment Unit you want to replace,
and pull it out halfway.
Important
❒ Pulling out the Development
Unit quickly might cause it to
drop.
B Hold the right side of the De-
velopment Unit with your
right hand, and pull out the
unit slowly.
Important
❒ Be careful not to touch the
right side of the Photocon-
ductor Unit.
❒ Be careful not to let it get in
contact with your hands or
clothes.
HHHH
Install a new Development Unit.
The procedure for attaching the
Development Unit is the same for
all four colors.
A Take the unit out from the bag.
ZDJH016J
ZDJH046J
ZDJH225J
ZDJH993J
ZDJH226J
JupP1k_GB_Mainte_F_FM.book Page 16 Thursday, August 22, 2002 4:23 PM