Ricoh AP3800C - Manual (Page 82)

Troubleshooting
72
4
Hardware Problem Finisher There is a problem with the
finisher. Turn the power switch off and
then on. If the message ap-
pears again, contact your sales
or service representative.
Hardware Problem HDD The printer identified a HDD
Board error. Remove and re-install the
HDD Board correctly.
If the message appears again,
contact your sales or service
representative.
See "Setting Up" in the Setup
Guide.
Hardware Problem IEEE1394 The printer identified an
IEEE1394 Board error. Remove and re-install the
IEEE1394 Board correctly.
A Confirm that the 1394 In-
terface Unit Type1045 is
attached to the computer
correctly.
B Confirm that the IEEE1394
interface cable is connect-
ed securely.
C Unplug the IEEE1394 in-
terface cable which is con-
nected to the printer.
D Restart the computer.
If the message appears
again even after executing
above operation, proceed
to the following steps.
E Execute the utility tool for
1394 Interface Unit
Type1045 which is stored
in the following path in the
CD-ROM labeled "Printer
Drivers and Utilities".
UTILITY\1394
Important
❒ For details about using
the utility tool for
IEEE1394, see the RE-
ADME file in the same
directory in the CD-
ROM.
If the message appears again,
contact your sales or service
representative.
See "Setting Up" in the Setup
Guide.
Messages/Second messages Description Solution
JupP1k_GB_Mainte_F_FM.book Page 72 Thursday, August 22, 2002 4:23 PM