Roland RD-700NX - Manual (Page 56)

57
Making Detailed Settings for Tones
Parameter Value Description
VRL (Velocity
Range Lower)
1–127 This specifies the lower limit (VRL) and upper limit (VRU) of the range in which the tone is played according to the velocity.
Make this setting when you want the tone to change depending on the key velocity.
This setting is disregarded with certain tones.
VRU (Velocity
Range Upper)
1–127
Sns (Velocity
Sense)
-63–+63
This setting determines how the volume changes in response to the velocity.
The volume is increased as the keyboard is played with greater force when a positive value is used; when a negative value is
selected, the volume decreases as the keys are played with greater force.
This setting is disregarded with certain tones.
Max (Velocity
Max)
1–127
Maximum velocity value for the corresponding key.
Lowering this value will produce softer notes even if you play the keyboard strongly.
This setting is disregarded with certain tones.
V .Reserve (Voice
Reserve)
0–64 Specifies the number of voices that will be reserved for each layer if you attempt to play more than 128 voices.
Dp
ON, OFF
Specifies whether the damper pedal will (ON) or will not (OFF) control each layer.
F1 Specifies whether the pedal connected to the FC1 jack will (ON) or will not (OFF) control each layer.
F2 Specifies whether the pedal connected to the FC2 jack will (ON) or will not (OFF) control each layer.
PB Specifies whether the pitch bend lever will (ON) or will not (OFF) control each layer.
Md Specifies whether the modulation lever will (ON) or will not (OFF) control each layer.
S1 Specifies whether the [S1] button will (ON) or will not (OFF) control each layer.
S2 Specifies whether the [S2] button will (ON) or will not (OFF) control each layer.
LW2 Specifies whether the control slider (LW2) will (ON) or will not (OFF) control each layer.
LW1 Specifies whether the control slider (LW1) will (ON) or will not (OFF) control each layer.
UP2 Specifies whether the control slider (UP2) will (ON) or will not (OFF) control each layer.
UP1 Specifies whether the control slider (UP1) will (ON) or will not (OFF) control each layer.