Roland RD-700NX - Manual (Page 44)

45
Using the Convenient Functions in Performances
Storing Settings to Live Sets
If you want to use the changed content as a new Live Set, use the following procedure to save the settings to user bank.
You can store 100 Live Sets on the RD-700NX.
You can also change the name of a Live Set.
1. Press the [ WRITE] button, getting the indicator to light .
As shown on the right screen appears.
2. Press the Cursor [ ] [ ] buttons to move the cursor to the
positions where the characters are to be input .
3. Use the [DEC] [INC] buttons or the VALUE dial to enter the
characters .
The following characters are available.
space, ! “ # $ % & ‘ ( ) * + , - . / 0–9 : ; < = > ? @ A–Z [ \ ] ^ _ ` a–z { | } ~
When the [TONE EDIT] (INSERT) button is pressed, a single-character blank space is inserted; pressing the [Layer EDIT] (DELETE) button deletes one
character.
MEMO
You can use the LIVE SET buttons to directly specify and enter characters.
4. Repeat steps 2–3 to input the name .
5. Press the Cursor [
] button to move the cursor to the destination Live Set number .
MEMO
Pressing the Cursor [ ] button, even while inputting the name, moves the cursor to the save-destination Live Set number.
6. Select the save-destination Live Set number, either by using the [DEC] [INC] buttons or the
VALUE dial .
When using the LIVE SET buttons to input Live Set numbers, press the [ENTER] button afterwards to set the
number.
7. When you have fi nished determining the save destination and the name for the new Live Set,
press the [ENTER] button or the [Layer EDIT] (WRITE) button .
The [ENTER] button’s indicator is fl ashing, and the confi rmation message appears.
If you do not want to save the Live Set, press the [EXIT/SHIFT] button or [WRITE] button.
8. When the [ENTER] button is pressed, saving of the Live Set begins .
When you have fi nished saving the Live Set, the [WRITE] button’s indicator goes out and you are returned to
the Live Set screen.
NOTE
Never switch off the power while “Executing...” appears in the display.
Settings Not Saved in a Live Set
The following settings cannot be saved to a Live Set.
• System Settings (p. 66)
• Compressor Settings (p. 76)
• V-LINK Settings (p. 83)
• Settings for Play Mode, Transpose, Center Cancel, and Part Switch under Song Function. (p. 84)
• Rec Setting (p. 86)
Pressing the [Layer EDIT] (WRITE) button in the Edit screen saves the System, and V-LINK settings.
New Live Set Name
Destination