Roland RD-700NX - Manual (Page 48)

49
Making Detailed Settings for the ONE TOUCH Tones
Parameter Value Description
Peaking Gain -15–+15 dB
Amount of boost/cut produced
by the filter at the specified
frequency region of the input
sound
Peaking Q 0.5, 1.0, 2.0, 4.0, 8.0
Width of the frequency region
boosted/cut by the Peaking Gain
parameter (larger values make the
region narrower)
HF Damp 16–15000 Hz, BYPASS
Frequency at which the high-
frequency content of the resonant
sound will be cut (BYPASS: no cut)
LF Damp Freq BYPASS, 16–15000 Hz
Frequency at which the low-
frequency content of the resonant
sound will be cut (BYPASS: no cut)
Lid 1–7
Adjusts the extent to which the lid
of the grand piano is open.
Level 0–127 Output Level
P-Sft Amount 0–127 Amount of fluctuations.
P-Sft Level 0–127 Volume of fluctuations.
P-Sft LPF 16–15000 Hz, BYPASS
Center frequency of filter used to
cut the high-frequency portions
of the fluctuations. (BYPASS: no
cut)
P-Sft HPF BYPASS, 16–15000 Hz
Center frequency of filter used to
cut the low-frequency portions of
the fluctuations. (BYPASS: no cut)
P-Sft to Rev 0–127
Amount by which the fluctuations
are made to resonate further.
Damper offset 0–64
Volume of additional slight
resonance when the damper
pedal is not pressed
Making the Equalizer Settings
This sets the equalization.
Parameter Value Description
Sw OFF, ON
When set to ON, the effect is
applied.
C2
Low Gain, High Gain,
Level
Selects the parameter to be
controlled with MFX 2 CTRL.
Low Freq 200, 400 Hz Frequency of the low range
Low Gain -15–+15 dB Gain of the low range
Mid1 Freq 200–8000 Hz Frequency of the middle range 1
Mid1 Gain -15–+15 dB Gain of the middle range 1
Mid1 Q 0.5, 1.0, 2.0, 4.0, 8.0
Width of the middle range 1
Set a higher value for Q to narrow
the range to be affected.
Mid2 Freq 200–8000 Hz Frequency of the middle range 2
Mid2 Gain -15–+15 dB Gain of the middle range 2
Mid2 Q 0.5, 1.0, 2.0, 4.0, 8.0
Width of the middle range 2
Set a higher value for Q to narrow
the range to be affected.
High Freq 2000, 4000, 8000 Hz Frequency of the high range
High Gain -15–+15 dB Gain of the high range
Level 0–127 Output Level
Restore the Settings to Initial Conditions
This restores the One Touch Piano settings to their initial conditions.
1. In step 3 of “Making Detailed Settings for the Piano Tones”
(p . 46), choose “5 . Initialize” and press the [ENTER] button .
The Initialize Screen appears.
To cancel the Initialize, press the [EXIT/SHIFT] button.
2. Press the [ENTER] button .
The confirmation message appears.
To cancel the procedure, press the [EXIT/SHIFT] button.
3. Press the [ENTER] button once again .
The ONE TOUCH PIANO button’s tones are initialized.