Changing a performance – Roland JV-1010 User Manual
Page 34
34
Changing Sounds from an External MIDI Device
Changing a Performance
When changing a performance, set the transmit channel of the external
MIDI device and the Performance Control Channel (Perform Ctrl CH) of the
JV-1010 to the same channel, then transmit the Bank Select and Program
Change messages.
Now let’s set the transmit channel on the external MIDI device and the
Performance Control Channel (Perform Ctrl CH) on the JV-1010 to the same
channel and try changing the performance.
fig.1-22
1
Press the VALUE knob and choose the Performance mode
(
PERFORM
).
Pressing the VALUE knob makes the mode change sequentially. Press the
knob several times until the PERFORM indicator lights up.
2
While holding down the VOLUME knob, press the VALUE
knob.
Switch to the Edit mode.
3
Turn the CATEGORY/BANK knob to choose
SYNTH/PAD
(
Perform Ctrl CH
).
4
Turn the VALUE knob and choose the channel.
A value of from
001
to
016
, or
OFF
flashes in the display.
5
While holding down the VOLUME knob, press the VALUE
knob.
The JV-1010 exits Edit mode.
For more information about
the performance, please refer
to
3
2,5
1,4
When you first take the
unit out of the box, the
setting for the Performance
Control Channel is at
OFF
.