Roland JV-1010 - Manual (Page 33)

33
Changing Sounds from an External MIDI Device
Quick Start
2
Press the VALUE knob to choose the Patch mode ( PATCH ).
Pressing the VALUE knob makes the mode change sequentially. Press the
knob several times, until the PATCH indicator lights up.
3
Turn the PART knob and choose 1 .
Here, 1 becomes the JV-1010’s receive channel.
4
Transmit a Bank Select MSB (Controller Number 0) value of 81
from the external MIDI device to the JV-1010
5
Transmit a Bank Select LSB (Controller Number 32) value of 1
from the external MIDI device to the JV-1010.
6
Transmit a Program Change 10 from the external MIDI device
to the JV-1010.
The display on the JV-1010 shows 010 to indicate the switch to the PRESET-
B patch No. 010 Hip Bass .
The correspondences between MIDI messages transmitted from external
MIDI devices and Patch Numbers are as shown below.
Patch Patch Bank Select Program
Group Number MSB LSB Number
USER 1–128 80 0 1–128
PRESET-A 1–128 81 0 1–128
PRESET-B 1–128 81 1 1–128
PRESET-C 1–128 81 2 1–128
PRESET-D 1–128 81 3 1–128
PRESET-E 1–128 81 4 1–128
Session 1–128 84 0 1–128
Session 129–255 84 1 1–127
WAVE-EXP 1–128 84 2 1–128
WAVE-EXP 129–256 84 3 1–128
Be sure to set the transmit
channel for the external
MIDI device and the
receive channel for the JV-
1010 to the same channel.
On the JV-1010, when just a
Program Change message
is received without
receiving a Bank Select
message, only patches and
rhythm sets within the
same group are changed.