Roland JV-1010 - Manual (Page 28)

28
Choosing and Playing Patches
■ Choosing Patches by Category
Here, let’s choose No. 008 Bright Piano from PIANO (the Piano category).
fig.1-17
1
Press the VALUE knob to choose the Patch mode ( PATCH ).
Pressing the VALUE knob makes the mode change sequentially. Press the
knob several times, until the PATCH indicator lights up.
2
Turn the CATEGORY/BANK knob to choose PIANO .
3
Turn the VALUE knob to choose 008 .
4
You can listen to the selected patch sound (PIANO No. 008
Bright Piano) by holding down the VOLUME knob.
At this time, the currently selected bank PrA (PRESET-A) and the patch
number 002 appear in alternation on the display.
fig.1-18a
When you release the VOLUME knob, the display shows the patch number
008 of the category group PIANO .
4 1,3 2
The patches you can choose
by category are Preset A, B,
C, D, and E, and Session
(XP-A) patches. The sounds
and categories of User and
WAVE-EXP (XP-B) patches
vary, so you can’t choose
these patches by category.
Turning the VALUE knob
rapidly makes the value
change in large increments.
Also, turning the VALUE
knob while pressing it in
jumps you to the value at
the start of each category,
in the currently selected
category group.
The start
values for by-category
patches are shown with
a
dot at the end of the
number on the display.
For more information
about the by-category
patches, take a look at
“Patch Category List” (p.
58).