beautypg.com

Remembering the settings (memory backup), Off, carry out the memory backup procedure (p. 80), P. 80 – Roland DP-990 User Manual

Page 80

background image

80

Various Settings

Normally, the settings of the various variations will revert to
their default values when the power is turned off. However,
you can specify that the various settings will be remembered
even when the power is turned off.
This function is called “Memory Backup.”

1.

Hold down the [Brilliance] button and press
the [3D] button.

The display will indicate “Fnc” and you’ll be in Function
mode.

fig.d-Fnc.eps

2.

Press the [Left] button.

The display will indicate “buP” and the [

] button

will blink.

3.

Press the [

] button.

The display will indicate “Sur,” and the [

] button

and [

] button will blink.

If you decide not to save the settings, press the
[

] button.

4.

To save the settings, press the [

] button.

Never turn off the power while “buP” is blinking in
the display.

When the memory backup has been completed, the
display will indicate “Fnc.”

fig.d-Fnc.eps

For details on the settings stored by the Memory
Backup operation, refer to p. 98.

The settings you’ve changed in Function mode can be restored
to their factory-set condition. This operation is called “Factory
Reset.”
Execute this operation if you want the settings you’ve stored
using Memory Backup to be returned to their original state.

When you execute “Factory Reset,” all settings
you’ve stored up to that point will be cleared, and
reset to their factory-set condition.

Executing this operation will not erase the songs
from internal memory or USB memory.

If you want to erase all songs from the DP-990‘s
internal memory and all songs from USB memory,
refer to “Initializing the Memory” (p. 60).

1.

Hold down the [Brilliance] button and press
the [3D] button.

The display will indicate “Fnc” and you’ll be in Function
mode.

fig.d-Fnc.eps

2.

Press the [Right] button.

The display will indicate “Fct” and the [

] button

will blink.

3.

Press the [

] button.

The display will indicate “Sur,” and the [

] button

and [

] button will blink.

If you decide not to execute the Factory Reset, press the
[

] button.

4.

To execute the Factory Reset, press the [

]

button.

Never turn off the power while “Fct” is blinking in
the display.

Remembering the Settings
(Memory Backup)

NOTE

Restoring the Settings to the
Factory Condition (Factory
Reset)

NOTE

NOTE

DP-990_e.book 80 ページ 2009年2月17日 火曜日 午前8時30分