Roland DP-990 - Manual (Page 41)

41
Performing
The volume of the metronome can be adjusted, with 11 volume levels available.
fig.Panel-MetronomeVol-e.eps
1.
While holding down the [Metronome] button, press the [-] or [+] button.
The display will indicate the metronome volume.
fig.d-5.eps
When the metronome volume is set to “0,” the metronome sound does not play.
A “count-in” is a count that is sounded before the song begins to play.
If you’re playing along with a song, you can sound a count to make it easier to
synchronize your own playing with the song.
fig.Panel-CountIn-e.eps
1.
Press the [ ] button while the metronome is sounding.
A two-measure count sounds before the song plays.
A “count-down” is a count that is sounded at the end of the song’s introduction (before
you begin playing the keyboard) (p. 73).
Changing the Volume
Sounding a Count to Keep your Timing Accurate
DP-990_e.book 41 ページ ２００９年２月１７日 火曜日 午前８時３０分