Roland DP-990 - Manual (Page 79)

79
Various Settings
Ordinarily, when playing back SMF music files for Roland
Piano Digital instruments (p. 99), the left-hand part is assigned
to the Track [Left] button, and the right-hand part is assigned to
the Track [Right] button. However, right-hand and left-hand
part assignments in certain SMF music files may differ.
If these are set to “Auto,” and as a result you are unable to use
the track buttons to control the left- and right-hand parts (p. 46)
properly, change the setting to “2/1 Part” or “3/4 Part.”
This setting can be used for SMF format songs other
than the internal preset songs. It will not affect
internal preset songs.
1. Hold down the [Brilliance] button and press
the [3D] button.
The display will indicate “Fnc” and you’ll be in Function
mode.
2.
Hold down the Track [Accomp] button and use
the [-] [+] buttons to make the display indicate
“trA.”
When you take your finger off the button, the display
will indicate the value of the setting.
3. Use the [-] [+] buttons to change the setting.
After changing this setting, try selecting the song
once again.
You can connect a commercially available USB CD drive to
the DP-990, and play back separately sold CD-ROMs created
for the VIMA (VIMA TUNES).
Songs on VIMA CD-ROM (VIMA TUNES) are programmed
with “recommended tones” suitable for each song.
When you select a song from a VIMA CD-ROM (VIMA
TUNES), recommended tones will be assigned to the DP-990’s
[Strings], [Voice], and [Others] tone buttons, and these three
tone buttons will blink.
When you press a flashing Tone button, the recommended
tone is then selected, enabling you to perform the selected
song using a tone matched to that song as it plays back.
You can set the DP-990 so that the recommended tones are
automatically assigned or not assigned.
1. Hold down the [Brilliance] button and press
the [3D] button.
The display will indicate “Fnc” and you’ll be in Function
mode.
2. Hold down the Track [Accomp] button and use
the [-] [+] buttons to make the display indicate
“rtn.”
When you take your finger off the button, the display
will indicate the value of the setting.
3. Use the [-] [+] buttons to change the setting.
This is set to “On” at the factory.
Changing the Parts Assigned to the
Track Buttons During SMF Playback
(Track Assign)
Setting Explanation
Auto
The part assigned to each track will be
determined automatically, depending on the
song file.
2/1 Part
Assigns Part 1 to the Track [Right] button, Part
2 to the Track [Left] button, and the remaining
parts to the Track [Accomp] button.
3/4 Part
Assigns Part 4 to the Track [Right] button, Part
3 to the Track [Left] button, and the remaining
parts to the Track [Accomp] button.
NOTE
NOTE
Switching VIMA TUNES Recommended
Tones (Recommended Tone)
Setting Explanation
When you select a song from a VIMA CD-ROM
(VIMA TUNES), recommended tones will
automatically be assigned to the DP-990’s [Strings],
[Voice], and [Others] tone buttons.
The recommended tones are not used, and only the
DP-990’s internal tones can be selected.
DP-990_e.book 79 ページ ２００９年２月１７日 火曜日 午前８時３０分