Roland VG-99 - Manual (Page 86)

86
Chapter 8 Other Functions
4. If you want to save the edited settings,
perform the Write procedure (p. 38).
* If you do not want to save, press [EXIT] to return to the Play screen.
You can assign your favorite patches to the [DIRECT PATCH 1] –
[DIRECT PATCH 5] buttons, then call up these patches just by
pressing the buttons.
1. Press [SYSTEM].
2. Press PAGE [ ] to go to Page 1.
3. Press [F2] (DIRECT).
The DIRECT PATCH screen appears.
4. Use the F1–F5 knobs to select the patches to
be assigned to [DIRECT PATCH 1]–
[DIRECT PATCH 5].
The numbers correspond, with DIR. PATCH 1 assigned with
the F1 knob, DIR. PATCH 2 assigned with the F2 knob, and so
on.
5. Press [EXIT] several times to return to the Play
screen.
About the Range of Controllers’ Change
This sets the operational range (range in which the value
actually changes) for an expression pedal, or similar controller
that changes the value of a setting in a continuous fashion,
when it has been set as the source.
If the controller adjustment moves beyond the enabled range of
operation, the value of the setting remains at the maximum
value or minimum value, without changing any further.
0 127 RANGE
LOW
RANGE
HIGH
200%
MIN
0%
MAX
Value
Degree to
Which Expression
Pedal Is Depressed
One Touch Call Up of Favorite
Patches (DIRECT PATCH)
Setting DIRECT PATCH
VG-99_e.book 86 ページ ２００７年７月５日 木曜日 午前９時２２分