Setting harmony, Setting the cosm amp tone, Used to make settings for the cosm amp. (p. 30) – Roland VG-99 User Manual
Page 30
30
Chapter 2 Creating Sounds
1.
Press [ALTERNATE TUNING].
2.
Press PAGE [
] to go to Page 2.
fig.01-060d
3.
Switch the function on or off with the F3 or F6
knob.
4.
If making detailed parameter settings for
HARMONY, press [F3] (HARMO) or [F6]
(HARMO).
fig.01-060d
5.
Set the desired parameter with [F1] (SELECT),
[F2] (SELECT) or with the F1–F2 knobs.
6.
If you want to save the edited settings,
perform the Write procedure (p. 38).
*
If you do not want to save, press [EXIT] to return to the Play screen.
For detailed information on all the parameters, refer to
1.
Press [COSM AMP].
2.
Press PAGE [
] several times to display Page
1.
3.
Use [F1] (ON/OFF) or the F1 knob to switch the
COSM AMP ON/OFF setting.
fig.01-060d
4.
Use [F2] (SELECT) or the F2 knob to select the
COSM AMP type.
5.
Press PAGE [
].
fig.01-060d
*
Each press of PAGE [
] takes you to the next screen in which
parameter settings are made.
6.
Adjust the desired parameter with [F1]–[F6] or
the F1–F6 knobs.
7.
Adjust the parameters until you achieve the
sound you want.
For detailed information on all the parameters, refer to
8.
If you want to save the edited settings,
perform the Write procedure (p. 38).
*
If you do not need to save the settings, press [EXIT] to return to the
Play screen.
Setting HARMONY
You can set the pitch for each key when the
HARMO parameter is set to USER.
Press PAGE [
] [
] to display the parameter you
want to set.
Setting the COSM AMP Tone
VG-99_e.book 30 ページ ２００７年７月５日 木曜日 午前９時２２分