Chapter 6 – Roland VG-99 User Manual
Page 65
65
Chapter 6 Using MIDI
Chapter 6
Selecting the Controller Used to
Control the Hold Function (HOLD CTL)
1.
Press [GUITAR TO MIDI].
The GUITAR TO MIDI screen appears.
2.
Press [F5] (SYSTEM).
3.
Use [F1] (SELECT) or the F1 knob to select the
controller you want to set.
Controllers to which HOLD CTL is assigned are enabled
simultaneously with parameters set in the SYSTEM
CONTROL ASSIGN settings (p. 167). Set CONTROL
ASSIGN to OFF if you want to use only the Hold
function.
You can select the way the Hold function operates. For
more details, refer to
Thinning Out Bend Messages (BEND
THIN)
Vibrato, slides, and other such data in guitar performances are
output as Pitch Bend messages.
For this reason, the receiving MIDI device may encounter problems
with operation when Pitch Bend messages containing large amounts
of data are included.
You can use the BEND THIN function to thin out the Pitch Bend
messages and control the volume of MIDI data.
1.
2.
Set the function to ON with [F2] (OFF/ON) or
the F2 knob.
Select OFF when you do not want to reduce the amount of
data transmitted in the Pitch Bend messages.
HOLD CTL
Controller
GK S1, S2
GK-3 DOWN/S1, UP/S2 switch
CTL 1–4
VG-99’s CONTROL 1, 2 buttons or foot
switch connected to CTL 3,4 jack
FC-300 CTL1–8
FC-300’s CTL 1, 2 pedals or foot switch con-
nected to CTL jacks 3–8
VG-99_e.book 65 ページ ２００７年７月５日 木曜日 午前９時２２分