84 chapter 8 other functions – Roland VG-99 User Manual
Page 84
84
Chapter 8 Other Functions
3.
Select the function you want to assign with
PAGE [
] [
], [F1]–[F6], and the F1–F6
knobs.
You can assign two different functions to one controller.
For example, you can assign separate functions to the
GK VOL (1) and GK VOL (2) displayed in the screen.
For more on PITCH and FILTER of the D BEAM controller,
refer to
“Controlling Sounds by Hand Motion or the Guitar
(p. 77). For more on PITCH and
FILTER of the Ribbon controller, refer to
Sounds with the Movement of Your Fingertip (Ribbon
The following section describes the parameters you
can set on each page.
*
The screen shown in the example is for ASSIGN1.
Page 1, 3
F1: SOURCE (ASSIGN1–16 only)
This selects the controller assigned to the function.
F3: SW (ON/OFF)
Setting this to ON enables the controller.
F4–F6: TARGET PARAMETER
Use these to select the parameter you want to assign.
You can quickly locate and select the desired parameter by first
narrowing down the parameter type with F4, then using F5 and
then F6 to reach the right parameter.
For more details on the parameters, refer to
Page 2, 4
F2: MIN
This sets the minimum value for the target’s controllable range.
F3: MAX
This sets the maximum value for the target’s controllable range.
F4: SW MODE (only when a switch type controller is selected for
SOURCE)
This specifies how the switches function.
Displayed
screen
Controller
ASGN 1
:
ASGN16
ASSIGN1
:
ASSIGN16
Settings for general purpose as-
signs you can set freely as control-
lers for MIDI messages and other
controllers in addition to those de-
scribed above.
F1–F6
DIRECT EDIT
Settings for the function knobs ar-
ranged below the VG-99’s LCD.
Available Settings Explanation
MOMENT
The parameter switches to the maximum
value only while the switch is held down,
and switches to the minimum value when
the switch is released.
LATCH
The value alternately switches between
maximum and minimum each time the
switch is pressed.
VG-99_e.book 84 ページ ２００７年７月５日 木曜日 午前９時２２分