Adjusting the screen’s contrast, Chapter 4 – Roland VG-99 User Manual
Page 51
51
Chapter 4 Global Device Settings (SYSTEM)
Chapter 4
The text and icons in the LCD screen may be difficult to make out
sometimes, such as immediately after the VG-99 is turned on or after
extended use. The conditions at the place where you are using the
VG-99 can also affect visibility. Should you run into this problem, try
adjusting the contrast.
1.
Press [SYSTEM].
2.
Press PAGE [
] to display Page 1.
3.
Press [F1] (LCD).
4.
Turn the F1 knob to adjust the contrast.
This sets the signals and levels output for each of the VG-99’s output
jacks and connectors (MAIN OUT, SUB OUT, and DIGITAL OUT).
1.
Press [SYSTEM].
2.
Press PAGE [
] [
] to display Page 2.
3.
Press [F1] (OUTPUT).
4.
Set the OUTPUT MODE parameter to SYSTEM
with [F1] (SELECT) or with the F1 knob.
*
If set to PATCH, the values set under
(p. 37) are enabled. The value in the
MIXER screen is disregarded, and instead the value < > is applied.
5.
Set the signal and level output to each output
with PAGE [
] [
] or with the F1–F6 knobs.
For detailed information on the parameters that can be
set, refer to
Adjusting the Screen’s
Contrast
Setting the Output Signal
and Level (SYSTEM OUTPUT)
VG-99_e.book 51 ページ ２００７年７月５日 木曜日 午前９時２２分