Roland VG-99 - Manual (Page 20)

20
Chapter 1 Outputting Sounds
Turn the OUTPUT LEVEL knob to set the volume to a suitable level.
fig.01-070
* The output from the SUB OUT connector (XLR type) remains
constant, regardless of the OUTPUT LEVEL knob setting.
* You can adjust the volume level by assigning this function to the
expression pedal or GK-3 GK volume control. For details, see
“Using the Switches, Pedals, and MIDI to Control the
Sounds (CONTROL ASSIGN)” (p. 82).
Use this procedure to set the type of device connected to the MAIN
OUT jacks.
fig.01-071
1. Press [GLOBAL].
The Global screen is displayed.
fig.01-072d
2. Press PAGE [ ] to go to Page 1.
3. Press [F4] (SELECT) or turn the F4 knob to set
the type of device to be connected to the MAIN
OUT jacks.
4. Press [EXIT] to return to the Play screen.
Adjusting the Volume Setting the Device (Amp)
Connected to MAIN OUT (Output
Select)
Value Explanation
JC-120
Use this setting when connecting to Roland’s
JC-120 guitar amp.
SMALL AMP
Use this setting when connecting to a small
guitar amp.
COMBO AMP
Use this setting when connecting to the guitar in-
put of a combo amp other than the JC-120 guitar
amp (where the amp and speaker or speakers are
combined in a single unit).
* Depending on your guitar amp, you may be
able to obtain good results with the JC-120
setting.
STACK AMP
Use this setting when connecting to the guitar
input of a stack-type guitar amp (where the
amp and speaker or speakers are separated).
JC-120 Return
Use this setting when connecting to the RE-
TURN of a JC-120.
COMBO Return
Use this setting when connecting to the RE-
TURN of a combo amp.
STACK Return
Use this setting when connecting to the RE-
TURN of a stack amp or the input of a rack
mounted power amp.
Set to STACK Return also when using a guitar
power amp and speaker cabinet combination.
LINE/PHONES
Use this setting when using headphones or
when connecting to a multi-track recorder for
recording.
3
3
4
1
2
VG-99_e.book 20 ページ ２００７年７月５日 木曜日 午前９時２２分